For most ordinary faucets, the water inlet part generally refers to the water inlet pipe. For the shower faucet, the water inlet part is connected by two accessories called “curved feet”. The curved foot of the shower faucet, the four-point interface is connected to the reserved port on the wall, and the six-point interface is connected to the two nuts of the shower faucet. For this accessory, it will be mentioned in the fixing part below. For the water inlet hose of the faucet, the most common and the most used is a braided hose. The outer layer of the pipe is called a braided protective layer, and there is a plastic pipe on the inner layer for water. The two ends of the single cold faucet are both four-point interfaces. There are some hot and cold faucets, such as the split hot and cold faucet, and the bathtub faucet is also connected to the water with this kind of pipe. One end of the pipe equipped with the hot and cold faucet is a four-point interface, which is used for connecting the angle valve, and the other end is an interface for connecting the hot and cold valve core.
When purchasing a faucet, many businesses are equipped with a water inlet hose. For the water inlet hose, we must first measure the distance from the corner valve at home to the installation hole of the faucet, and determine how long the hose needs to be. use. The second thing is to check the quality of the hose, tie the soft bend into a knot, or break it in several places. If the hose bounces well and has no damage, the quality is better. The same kind of tube quality is poor.
As the name suggests, the fixed part
is to fix the faucet in a certain position to prevent it from shaking. For the shower faucet, the fixing part is the curved foot mentioned above. The curved foot has a very large effect. The first is to connect the water inlet, and the second To adjust the spacing, the third is to fix the force, so when you buy a shower head, you must pay attention to this accessory, choose 304 stainless steel or thickened copper, do not consider the iron one, to prevent In the future, the shower head is rusted and can’t be removed. The copper one should also be thicker. The copper material is relatively soft. If the wire opening on the outer surface of the curved foot is slightly deeper, it is easy to perforate. If the perforation is made, water will leak. We have encountered this problem when doing large-scale projects before. The hardness of 304 stainless steel is relatively high, so don’t be too thin.
For ordinary faucets, the most common and most used fasteners are the pins and horse iron shoes. The horseshoe is the first fastener to be used. Its advantage is that it is suitable for most of the installation holes. A single screw has almost no requirements on the opening, as long as it can pass through. The disadvantage is that only one screw is used to fix the faucet. For some comparisons Heavy and big faucets always feel that the force is not enough and not so strong. Now the most common is the pin holder, the pin must be much firmer than the screw, but the pin holder has requirements for the opening, which must be within a certain diameter range.
When purchasing a faucet, if it is installed on the stainless steel sink in the kitchen, the common pins are universal; if it is installed on the countertop and needs to be opened on the countertop, it is recommended to know the diameter of the pin first. Or buy the faucet first and then open the hole; if it is installed on the washbasin of the washbasin, the washbasin with only one mounting hole, the pins are common, pay attention to the washbasin with three mounting holes, that hole It is relatively small and can only be installed with a double-hole faucet. The pins of a single-hole faucet are too large to be installed.
Post time: Aug-31-2022