Not all bathrooms are suitable for shower rooms. First of all, it is necessary to ensure that the bathroom has a space of more than 900*900mm, which will not affect other equipment, otherwise the space is too small and there is no need to do it. It is recommended not to make the shower room closed, to avoid the temperature being too high, the glass door will be broken by heat, and to avoid the entry of no oxygen, which will suffocate the mouth and nose in the water vapor, so leave the door and the ground about 1 cm more, or leave more space on the upper floor. 2-3 cm.
Small space If the overall space is relatively small, it is recommended to use a shower curtain to replace the separate area of the shower screen, and it can help the space to obtain more comfort and flexibility. When you decide to use the shower curtain as a partition, remember to match the water retaining strip to achieve a more perfect dry and wet separation effect.
If the overall area is moderate or large, the shower screen can be used. In general, the glass shower screen is one of the most popular choices at the moment, which is divided into closed type and semi-open type. In addition to standard glass partitions, half-wall partitions are also a good design method, but there are certain requirements for the area. If the bathroom is small, don’t force it.
There are two ways to install the water retaining strip: pre-embedded and direct installation. Pre-embedded should be installed before the shower room enters the site. The advantage is that it is firm and strong, and the disadvantage is that it cannot be removed and cannot be repaired.
or the location where the floor drain of the shower room is installed, it is recommended to install it on the inner side, and the drainage effect will be better.
For the shower door, some like the hinge type, and some will make the slide rail type in order to save space, but if it is the slide rail type, a layer of waterproof should be made between the door and the bathroom floor tile. It is best to make a small step for the shower room to avoid unnecessary water splashes when the water flows down the elbows and flows out during the bath.
The floor of the shower room needs to be slightly inclined by about 1.5 cm because of the need to discharge water, but if it is done together with the floor of the bathroom, it may be a little more inclined than the usual bathroom, because it is necessary to ensure that no water accumulates, which is also Reasons why I recommend making a small step for the shower enclosure so that a floor can be made by itself.
However, you still need to pay more attention to cleaning, because it is often in contact with water vapor to avoid rust, deformation, etc. The glass facade is more prone to water stains and stains. Regularly wash with glass water to maintain the smoothness of the glass, and use it if there is dirt. Wipe with a soft cloth with a neutral detergent, and remove stubborn stains with a small amount of alcohol.
Sliding sliding doors are generally equipped with sliding rails at the base and top edge of the shower room, and the door slides back and forth in the sliding rails. Because the slide rail is easy to accumulate dirt or hard objects can not be cleaned, it is easy to make the door switch not smooth and forcibly back and forth to cause damage, so it is necessary to pay attention to cleaning frequently. The hinge type will be much more convenient, just pay attention to the rust problem of the right-angle fixer or the iron triangle bracket, and replace it in time to avoid aging and falling off, causing the facade to fall.
Post time: Sep-13-2022