The kitchen sewer is blocked and dredged. The sewer pipe of the kitchen sink is blocked, which is a common problem. After the pipe blockage occurs, it should be dredged immediately, otherwise it will cause sewage overflow.
The sewer pipe is blocked. Generally, the elbow is blocked, that is, the position of V-shaped trap.
The current sewer pipes are generally such sewer pipes with threaded knob covers. This cleaning is relatively simple, and the pipes can be removed and cleaned directly. Before removing the pipe, it is best to pad a basin under it to receive waste water. To avoid soiling the ground. After the pipe is removed, rinse it with water. Then assemble it and connect it back. It’ll be done in ten or twenty minutes. If it’s not the kind of threaded cover, you can only poke two hooks and press three times. Anyway, you have to dredge it all the way.
Generally, the downcomer is equipped with a basket. The basket is in the downcomer head to filter and collect the residue in the sink.
So usually, when the basket is full of residue, pour it out in time. In order to avoid residue in the lower head for a long time, resulting in blackening and pollution collection in the lower water device. It is not easy to clean at ordinary times, and it is easy to send out peculiar smell.
Some water appliances do not have such a basket. Even if there is an insulating layer on the surface, it also has the function of collecting residues. Just cleaning is not as convenient as carrying a basket, and the surface capacity is relatively small.
The sink is black and moldy. The installation of the water tank needs glue to ensure the stability and sealing of the water tank. However, the general glass glue is easy to blacken and mildew after a long time of use. Because the kitchen sink often needs to be in contact with water, the humid environment is an important factor in the mildew of glass glue.
There is no particularly good way to deal with the moldy side of the sink. General cleaning methods can only maintain beautiful effects for a short time. A better way is to directly cut off the moldy sealing glue at the edge of the sink and replace it with the anti moldy glue for edge sealing. However, it should be noted that some anti mildew adhesives on the market do not play a great role in terms of adhesion. Therefore, if you want to change the glue, you need to fully consider the stability of the water tank.
If this problem is analyzed from the installation mode of the sink, the installation of the basin on the stage or in the middle of the stage is two obvious installation modes with mildew and blackening. Because the gluing part of the sink is directly exposed on the surface, when the kitchen is cleaned, some oil and water will exist in the gap near the sink. This also accelerates the mildew at the edge of the sink. The basin under the stage is not so easy to get black and moldy because it is installed under the table. Even if it is black and moldy, it is not easy to be noticed. And cleaning is relatively simple. Just brush it with a brush and flush it with water. Directly washed away in the sink.
Post time: Aug-06-2021